Field Installation and Service Manual IMS106 | Page 4

Cutting a Tapered Filler on a Table Saw
2-3/4”
Wide
Dimension
2-1/2”
Narrow
Dimension
Waste
Tapered
Filler
Push material
through saw
with slight
pressure
towards the
fence
2-3/4”
Wide
Dimension
Finish taper
cut with
material
against
the fence
Start the taper cut
at the marked narrow
end of the scribe piece. Line
up the blade on the marked scribe material, not the fence
3B.3 Tapered 3B.4 Tapered 3B.5 Tapered
To safely taper a scribe on a ta-
ble saw, set the table saw fence
for the larger dimension. Starting with the end that is
marked with the narrow dimen-
sion, visually align the scribe
piece so the blade will cut on
the outside of the mark. Start the saw and proceed with
the cut while slowly allowing
the workpiece over its length to
travel toward the fence.
Plan to cut the scribe with the
waste portion to the outside of
the blade.
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
The cut should fi nish with the
workpiece completely against
the fence.
Section 1: IMS 106
4