Field Installation and Service Manual IMS102 | Page 7

102
3.2
Mark the Wall Cabinet Index Line height from the
Highpoint of the fl oor.
Once the Wall Cabinet Index Line height is established,
from the fl oor at the Highpoint measure its height from the
Base Cabinet Index Line.
Use this dimension to mark the wall at intervals above the
Base Cabinet Index Line and trace the Wall Cabinet Index
Line lightly onto the wall. Make sure that both lines are
parallel and horizontal.
Step 4
Calculating Run Length and Filler Sizes
Your installation can proceed effi ciently and with the least likelihood of installation layout errors if each cabinet and appli-
ance location is marked on the wall.
With the Base and Wall Cabinet Index Lines already marked, you can now mark accurate locations of the cabinet boxes
and appliance openings by drawing light vertical lines showing where each cabinet edge aligns, along with the corre-
sponding cabinet number written in the area behind where it will be installed. The following will describe how this can be
done quickly.
Field Tip:
Minimum Filler Widths
Minimum width for a wall cabinet
fi ller is 1” wide.
Base cabinet fi llers may be as
small as 1” if they span to a wall.
Base cabinet fi llers must be at
least 2” wide if they make up
either side of an inside corner.
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 102
7