Field Installation and Service Manual IMS102 | Page 10
Step 5
Transferring Individual Cabinet Names and Locations
to the Walls
Field Tip:
Once you understand what the
total amount of fi ller or reveal
area is going to be for a run of
cabinets and any constraints
that affect the corners, begin to
lay out the cabinet positions.
Common
“Front to Back”
actual cabinet box
depths:
Starting at one end of a wall,
mark the edge locations of
each cabinet, space and fi ller
in the Base Run with a small
vertical line.
Base 23-3/4”
Vanity 20-3/4”
15”Wall 14-7/8”
Wall 11-3/4”
5.1
Beginning with the corner of the most complicated wall, measure out the Base Cabinet Depth
dimension. (A)
Make a small mark on the Base Index Line and label the area being measured with the space or cabinet
that is to be mounted in that area.
Complete the same for the fi ller and any cabinets or appliance spaces specifi ed. (B through G)
Check your layout by adding all the cabinet widths, fi llers and spaces. Confi rm that the position on the wall
you arrived at is accurate to the sum of the dimensions.
Make any corrections needed before you proceed.
Laying Out a Base Cabinet Run and Marking Cabinet Locations
Base
Cabinet
Index Line
Refer
Space
F.
5/8”
57” E.
33” D.
30-1/4” C.
33”
B33
#1 Oven
Space
30-1/4” B33
#2
34-1/2”
B.
2-1/2”
G.
39”
Wall
Cabinet
Index Line
A.
23-3/4”
Base
Cabinet
Depth
Start
Here
Floor Highpoint
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 102
10