Chemwatch : 34-9548 Version No : 4.1.1.1
Page 6 of 11 Fido ' s Flea Shampoo For Cats and Dogs
Issue Date : 02 / 13 / 2014 Print Date : 06 / 27 / 2016
Fido ' s Flea Shampoo For Cats and Dogs
Material BUTYL NEOPRENE VITON NATURAL RUBBER PVA
CPI
* CPI - Chemwatch Performance Index A : Best Selection B : Satisfactory ; may degrade after 4 hours continuous immersion C : Poor to Dangerous Choice for other than short term immersion NOTE : As a series of factors will influence the actual performance of the glove , a final selection must be based on detailed observation . - * Where the glove is to be used on a short term , casual or infrequent basis , factors such as " feel " or convenience ( e . g . disposability ), may dictate a choice of gloves which might otherwise be unsuitable following long-term or frequent use . A qualified practitioner should be consulted .
A A A C C protection is required . Degree of protection varies with both face-piece and Class of filter ; the nature of protection varies with Type of filter .
Required Minimum Protection Factor
Half-Face Respirator
up to 10 x ES A-AUS P2 -
up to 50 x ES -
Full-Face Respirator
A-AUS / Class 1 P2
Powered Air Respirator
A-PAPR-AUS / Class 1 P2
up to 100 x ES - A-2 P2 A-PAPR-2 P2 ^
^ - Full-face A ( All classes ) = Organic vapours , B AUS or B1 = Acid gasses , B2 = Acid gas or hydrogen cyanide ( HCN ), B3 = Acid gas or hydrogen cyanide ( HCN ), E = Sulfur dioxide ( SO2 ), G = Agricultural chemicals , K = Ammonia ( NH3 ), Hg = Mercury , NO = Oxides of nitrogen , MB = Methyl bromide , AX = Low boiling point organic compounds ( below 65 degC )
None under normal operating conditions .
-
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Appearance Clear orange viscous liquid with a fragranced odour ; mixes with water .
Physical state |
Liquid |
Relative density ( Water = 1 ) |
1.020-1.030 |
Odour |
Not Available |
Partition coefficient n-octanol / water |
Not Available |
Odour threshold |
Not Available |
Auto-ignition temperature (° C ) |
Not Available |
pH ( as supplied ) |
Not Available |
Decomposition temperature |
Not Available |
Melting point / freezing point (° C )
Not Available Viscosity ( cSt ) Not Available
Initial boiling point and boiling range (° C ) |
> 100 |
Molecular weight ( g / mol ) |
Not Applicable |
Flash point (° C ) Not Applicable Taste Not Available Evaporation rate Not Available Explosive properties Not Available
Flammability Not Applicable Oxidising properties Not Available
Upper Explosive Limit (%) |
Not Applicable |
Surface Tension ( dyn / cm or mN / m ) |
Not Available |
Lower Explosive Limit (%) |
Not Applicable |
Volatile Component (% vol ) |
< 1.0 |
Vapour pressure ( kPa ) Not Available Gas group Not Available
Solubility in water ( g / L )
Vapour density ( Air = 1 )
Miscible pH as a solution ( 1 %) Not Available
Not Available VOC g / L Not Available
SECTION 10 STABILITY AND REACTIVITY
Reactivity See section 7
Chemical stability
Possibility of hazardous reactions
Unstable in the presence of incompatible materials . Product is considered stable . Hazardous polymerisation will not occur .
See section 7
Conditions to avoid See section 7 Incompatible materials See section 7