Chemwatch: 22-2369
Page 7 of 14
Version No: 3.1.1.1
Issue Date: 02/13/2014
Print Date: 06/27/2016
Fido's Everyday Shampoo
PVA
C
PVC
C
TEFLON
C
VITON
C
* CPI - Chemwatch Performance Index
A: Best Selection
B: Satisfactory; may degrade after 4 hours continuous immersion
C: Poor to Dangerous Choice for other than short term immersion
NOTE: As a series of factors will influence the actual performance of the
glove, a final selection must be based on detailed observation. * Where the glove is to be used on a short term, casual or infrequent
basis, factors such as "feel" or convenience (e.g. disposability), may
dictate a choice of gloves which might otherwise be unsuitable following
long-term or frequent use. A qualified practitioner should be consulted.
gas or hydrogen cyanide(HCN), B3 = Acid gas or hydrogen cyanide(HCN),
E = Sulfur dioxide(SO2), G = Agricultural chemicals, K = Ammonia(NH3),
Hg = Mercury, NO = Oxides of nitrogen, MB = Methyl bromide, AX = Low
boiling point organic compounds(below 65 degC)
Cartridge respirators should never be used for emergency ingress or in
areas of unknown vapour concentrations or oxygen content. The wearer
must be warned to leave the contaminated area immediately on detecting
any odours through the respirator. The odour may indicate that the mask is
not functioning properly, that the vapour concentration is too high, or that
the mask is not properly fitted. Because of these limitations, only
restricted use of cartridge respirators is considered appropriate.
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Appearance
Physical state
Clear green coloured, fragranced viscous liquid; mixes with water.
Relative density
(Water = 1)
Liquid
1.03-1.04
Odour
Not Available
Partition coefficient
n-octanol / water
Odour threshold
Not Available
Auto-ignition
temperature (°C)
Not Applicable
pH (as supplied)
Not Available
Decomposition
temperature
Not Available
Melting point /
freezing point (°C)
Not Available
Viscosity (cSt)
Not Available
Initial boiling point
and boiling range (°C)
Not Available
Molecular weight
(g/mol)
Flash point (°C)
Not Applicable
Evaporation rate
Not Available
Not Applicable
Taste
Not Available
Not Available
Explosive properties
Not Available
Flammability
Not Applicable
Oxidising properties
Not Available
Upper Explosive Limit
(%)
Not Applicable
Surface Tension
(dyn/cm or mN/m)
Not Available
Lower Explosive Limit
(%)
Not Applicable
Volatile Component
(%vol)
Vapour pressure (kPa)
Not Applicable
Gas group
Not Available
pH as a solution (1%)
Not Available
VOC g/L
Not Available
Solubility in water
(g/L)
Vapour density (Air =
1)
Miscible
Not Available
SECTION 10 STABILITY AND REACTIVITY
Reactivity
Chemical stability
See section 7
Unstable in the presence of incompatible materials.
Product is considered stable.
Hazardous polymerisation will not occur.
Possibility of
hazardous reactions
See section 7
Conditions to avoid
See section 7
Incompatible materials
See section 7
Hazardous
decomposition
products
See section 5
1