If there is an error, error code will be showed at the heater displays.
ERROR CODE
POSSIBLE CAUSES
ERROR ELIMINATION
E1 Cooling Fan is disabled Contact Whirlpool After Sale Service
E3 Supply voltage is over than rated Turn the hob off, wait until“H”disappears for all
values zones and then turn the hob on. If same error is
appeared again, contact Whirlpool After Sale
Service
E4
Supply frequency is different from Turn the hob off, wait until“H”disappears for all
rated values zones and then turn the hob on. If same error is
appeared again, disconnect the hob from the
mains supply and connect it again. If same error is
still appeared, contact Whirlpool After Sale
Service
E5 Hob inside temperature is too high
E6 Communication error between
Turn the hob off and wait for hob to cool down.
touch control and heater
E7 Coil temperature sensor is disabled
E8 Cooler temperature sensor is
Contact Whirlpool After Sale Service
disabled
E9
Calibration error
18