GB
Conversion from liquid gas to natural gas
After removing the front panel, light the over with
thermostat set to 250°C for at least 10-15 minutes.
Then, turn the thermostat to the minimum position.
Then turn the bypass screw A counterclockwise until
you see a reduced by stable flame.
FLUSH FITTING
Check that the flame does not go out when the door
of the oven is opened and closed repeatedly. If the
flame goes out, slight increase the minimum regulation
setting.
After converting the appliance to a different type of
gas, remember to change the data plate to one with
the new data (gas type and pressure).
REPLACING THE GAS GRILL NOZZLE
1) Remove the burner screw located at the top front of
the oven cavity.
2) Remove the burner together with its heat elements.
3) Remove the nozzle using the 7 mm socket wrench.
4) Fully tighten the new nozzle which must be of the
diameter indicated in the table on page 4.
5) Put back the burner and secure it with the screw.
The oven can be installed under a work top or in a
cooking column. The dimensions of the housing for the
oven are given in figure. Make sure that surrounding
materials are heat resistant.
Align the oven centrally with respect to the side walls
of the units surrounding it and fix it in place with the
screwsand Allen screws provided.
ELECTRICAL CONNECTIONS
Before connecting the ovento the mains power supply,
make sure that:
- The supply voltage corresponds to the specifications
on the data plate on the front of the oven.
- The mains supply has an efficient earth (ground)
connection complying with all applicable laws and
regulations. Correct earthing (grounding) is a legal
requirement. The power cable should never reach
a temperature 50° C above ambient temperature
at any point along its length. If a fixed appliance is
not provided with a power cable and plug, or some
other device permitting it to be disconnected from
the mains electricity supply, with a gap between
5