African Mining October 2025 | Page 30

• HEALTH AND SAFETY
the mistracking. Unfortunately, this approach does not work on reversing belts. An even more serious consequence is that over time a number of the idlers may be misaligned, effectively“ fighting” each other to correct the alignment.
When idler training is not successful as a long-term solution, operators may be faced with a situation where the training procedure is repeated on a frequent( sometimes daily) basis. At that point, managers should consider installing some form of engineered training solution to mitigate the problem( Figure 5).
Figure 5: The Torsion Arms sense changes in the belt path and adjust the roller to compensate.
Engineered training solutions are devices that sense the position of a belt and, through a mechanism or geometry change, actively adjust its path. Some of the most common types include:
• Belt misalignment switches – the wandering belt pushes a lever arm and activates a switch, which either sets off an alarm or stops the system. Costly downtime can result from these systems. Vertical edge guides – these are positioned perpendicular to the belt’ s path to keep the edge away from the conveyor structure and should not be used to compensate for persistent misalignment problems. These are most practical on short, low-tension systems and not particularly effective on thin belts – operators have experienced the belt roll over on itself.
• Vee idlers and rollers – set on both the cargo side and return side of the belt, these use a trough configuration and edge brackets that rely on a centreing force to correct the belt path, which can add stress on the belt and lead to damage. These systems are more expensive and require more maintenance than a conventional return idler.
• Crowned pulleys – the raised portion of the pulley( the crown) touches the belt first and the outer sections of the belt on both sides produce a force driving it toward the centre( Figure 6).
Increased belt speeds and greater cargo loads mean that some systems are equipped with belt tracking devices that aren’ t able to handle the higher thresholds.
Figure 6: This roller tracker uses a unique ribbed lagging made of durable polyurethane to increase performance.
• Dynamic belt-tracking systems – these use the force of the mistracking belt on an arm that moves an idler, creating a steering action that directs the belt back into the centre. In-line sensing roll trainers have vertical guide rolls that are mounted on both sides of the belt, in line with the roller, with the centreline running through the idler’ s pivot point. Movement of the belt against either guide roll causes the roll to move in the direction of the misalignment, pivoting the entire idler( Figure 7).
Figure 7: The in-line sensing roll trainer has a carrying roll on a central pivot bearing with vertical guide rolls mounted on both sides.
• Leading sensing-roll trainers – employing either a pivoting carrying roll or troughing set, short arms on both sides of the frame are positioned in advance of the pivoting roller and end in guide rolls located 25 to 75mm( 1 to 3 inches) from the belt edge. Torsion-spring trainers – these improve upon the leading sensing-roll trainer design by removing one sensing roll and incorporating a spring into the pivot, which keeps the one remaining sensing roll in constant contact with the belt edge.
• Multi-pivot belt trainers use longer arms than other designs, positioning the guide rolls further from the pivot roller, as well as closer to the belt edge. The closer proximity allows guide rolls to sense slight misalignments and make immediate corrections. Rather than waiting for a powerful mistracking force, the longer arms require considerably less force to move the pivot roller. The result is better correction with no pinch points and less wear on conveyor and tracking equipment, for a longer and more efficient service life( Figure 8).
28 • African Mining • October 2025 www. africanmining. co. za