• HEALTH AND SAFETY to correctly centre the belt. Wandering is prevented by first understanding the basic patterns of belt behaviour and then following established procedures to carefully align the structure and components to correct any fluctuations in the belt’ s path.
Mistracking indicators Belt drift can begin in any part of the conveyor system, and identifying mistracking through a comprehensive review of the entire conveyor system( such as Martin Engineering’ s Walk The Belt™ program) is the first step toward correction. All these traits could be indicators of belt mistracking, which itself could have one or more root causes( Figure 2).
Figure 2: Conveyor belts that are out of alignment are capable of‘ sawing’ through steel components, in this case a seized training idler.
There are three groups of common causes for mistracking. The first is a fault with the belt or splice, second is the conveyor’ s structure, components or environment, and third is due to improper material loading.
• Edge Fraying( Figure 3) – probably an indication that the belt is rubbing on the conveyor frame at some point, degrading the edge, reducing the usable width and increasing the chance of a fire.
• Excessive spillage – could mean that one side of the belt has drifted higher on the trough angle, allowing cargo to discharge along the belt path.
• Idler fouling – an off-centre load and uneven belt plane can foul idlers. Bearing abrasion can then cause the idler to seize, and the ensuing friction against the running belt can erode its coating and increase the risk of fire.
• Off-centre at head or tail pulley – this type of drift can lead to a fast-moving belt coming in contact with the conveyor stringer structure. There is also a chance of splice failure, which puts the entire system in jeopardy and creates heightened safety risks.
• Lack of tail pulley protection – on many systems, the belt
26 • African Mining • October 2025 www. africanmining. co. za