THE 37th BANGKOK INTERNATIONAL MOTOR SHOW 2016
Requirements for exhibition area
A4, A6, A8, A10, A12, A14, A16, A18, A19, A19/1, A20, A20/1
B (Building) is the area in which opaque decorative parts and
double storey booth not higher than 8.00 meters could be
constructed within the boundary of “B” zone in which the size
is vary from each booth, based on the outline prescribed in
each drawing.
W (Wall) is the location where a rear wall of the height not
exceeding 7.00 meters could be erected, whereby the wall shall
possess enough strength and stability to stand on its own
without supporting base protruding outside the booth space as
this is strictly prohibited.
W1 (Wall 1) is the location where an adjacent wall of the height
not exceeding 3.00 meters could be erected along the
designated adjacent booth boundary line, whereby the wall
shall possess enough strength and stability to stand on its own
without supporting base protruding outside the booth space as
this is strictly prohibited. Also, the company logo installation
facing toward other booth is strictly prohibited.
D (Display) is the shaded area where a portion of which
decorative parts could be constructed, however the opaque
decoration is not allowed. These parts are divided as follows:
1. Automotive stand not higher than 0.80 meter; and
2. Other decorative parts not higher than 2.00 meters, subject
to attractiveness and un-obscure vision of other booths.
F (Floor)
1. Raising the floor from the original floor level is permitted in
the range 0.10 - 0.30 centimeters.
2. After raising the floor, all sharp corners shall be covered
with rubber guard.
3. Booth with raised floor shall have sloped entry and exit
walkways for disable person.
P (Pylon) is the area assigned for installation of a company
name board and / or logo, with the following requirements. The
Exhibitor is required to install the company name board and / or
logo at the designated point as prescribed by the Organizer in
each drawing only:
1. The width x thickness x height size of the board shall not
exceed 1.80 x 0.80 x 7.00 meters; and
2. A steel base which measures at least 1.00 meter on each
side shall be installed to support the board. It shall be
strong and capable of holding the board firmly. A carpet
shall be laid on the floor before installing, and the
Organizer’s personnel shall be asked to inspect the
installation before covering the area with flooring material.
75
คูมือกอสราง