540 7-3. Do-it-yourself maintenance
� Type C
A Normal fuse Blown fuse
n After a fuse is replaced
lWhen installing the lid, make sure that the tab is installed securely.
lIf the lights do not turn on even after the fuse has been replaced, a bulb may need replacement.
lIf the replaced fuse blows again, have the vehicle inspected by your SUBARU retailer.
n If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
n When replacing an electronic component, such as a lights, etc.
SUBARU recommends that you use
genuine SUBARU products designed for this vehicle. Because
certain bulbs are connected to circuits designed to prevent overload, non-genuine parts or parts not designed for this vehicle may be unusable.
WARNING
n To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or injury.
lNever use a fuse of a higher amperage rating than that indicated, or use any other object in place of a fuse.
lAlways use a genuine SUBARU fuse or equivalent. Never replace a fuse with a wire, even as a temporary fix.
lDo not modify the fuses or fuse boxes.
NOTICE n Before replacing fuses
Have the cause of electrical overload determined and repaired by your SUBARU retailer as soon as possible.