166 4-2. Opening, closing and locking the doors
how to hold the electronic key or circumstances, it may not be detected properly.
All the doors other than the back door will be locked, and after the back door is closed, the back door
will also be locked. When all the doors have been closed and
locked, the buzzer will sound and the emergency flashers will flash.
The standby state is canceled if you
do not move away from the back door for 30 seconds. To operate the
function again, perform the procedure again from the beginning.
If the switch is pressed after the
back door operation has stopped, the close & lock( Walk-Away) function will go into standby again.
n Using the back door handles
Lower the back door using the back door handle.
The power back door closing assist( �P. 168) will be activated, and the power back door will fully close automatically.
n Using the kick sensor( vehicles with Hands Free Power Back Door)
When operating the Hands Free Power Back Door, make sure that the power switch is in OFF, the Hands Free Power Back
Door operation is enabled( �P. 169) and you are carrying an electronic key. 1 While carrying an electronic key, stand within the smart key system operation range, approximately 19.7 to 27.6 in.( 50 to 70 cm) from the rear bumper.
A Kick sensor
B Hands Free Power Back Door operation detection area
C Smart key system operation detection area( �P. 176) 2 Perform a kick operation by moving your foot to within approximately 3.9 in.( 10 cm) of the rear bumper and then pulling your foot back after the buzzer sounds.
• Perform the entire kick operation within 1 second.
• The Hands Free Power Back Door will not start operating while a foot is detected under the rear bumper.
• Operate the Hands Free Power Back Door without