Family Creation 4 & Shared Parameters
Place two Ref Lines as
indicated in the adjacent
image. Flex the model to
check that the Ref. Lines keep
their constraints.
Place dimensions between the
ends of the Ref. Lines. I.e.
dimension the length of each
Ref Line. Give these
dimensions the following
parameter properties.
tt. Name = Panel Width Half
uu. Discipline = Common
vv. Type of Parameter =
Length
ww. Grouping = Dimensions
xx. Type/Instance = Type
Give each of these Ref. Lines
a separate angle dimension to
the Centre Front/Back Ref
Plane. Make this dimension
with the following parameter
properties.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 17 of 27