Detailing and annotations
Pink dots )
= Dot ( for creating
The hatch pattern we will make is called ; Off-Shutter Concrete Uniform Panel and will be 1200mm x 1200mm .
Draw a square of these proportions using the Hatch22 – Boundary line ( Red )
Use the normal black Thin Line to create a reference for where the bolt or tie holes are going to be .
You cannot draw circles using hatch22 you must use the ‘ Inscribed Polygon ’ draw tool . In the Options Bar set the sides to 12 . Draw a polygon using the black Thin Lines intersection as the centre . The radius can be of your choice but do not make it too small . Copy this polygon to the other corners of the square .
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : shaun @ modena . co . za
Physical Address : 5 Pont Road , Bryanston , Johannesburg
Page 24 of 50