Stairs & Railings
Create an Angled Rail.
1. The next rail was created
as a Faced Base Generic
Model. Then Nested into a
generic model. In the
Generic Model there is a
reference Line with a
parameter to define an
angle of the family.. Open
Flat bar Post
2. Load the family into the
project.
3. In the PB > Railings >
Handrail Type, Duplicate
and Call it Angled Posts.
4. Double Click. Change the
Straight Baluster out with
the ‘Flat Bar Post”
5. OK
6. Edit Type Rail > Change
the Handrail 1 to Angled
post
7. OK
8. Select one Support in the
project, Type SA.
9. Unpin
10. Select only the posts on
the angel and swop them
with the Flat Bar Post
Family
END
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 23 of 24