Assisgnment – Site & Project Setup
REVIT CCP WORKSHOP ASSIGNMENT
– SITE & PROJECT SETUP
[email protected]
WORKSHOP ASSIGNMENT 1 – SITE & PROJECT SETUP
Autocad File
1. You can open up the
Plan-survey.dwg file
and immediately save it
as Plan-survey
import.dwg. This is just
a precaution in case the
original file gets
damaged in your attempt
to clean it before
importing.
2. You need to clean up the
drawing as much as
possible before bringing
it into Revit to generate
topography from.
3. These are the main
points of attention
The correction of
the contour heights,
in this project the
ground level initially
will be set at
1188m.
The Orientation of
True North
Flattening the
information that
does not require 3
Dimensional
information
Revit
1. You will need to
import Plan-survey
import.dwg into a
clean revit project.
2. The Project Height for
Tel : 086 166 3362
Imported in a True north orientation
Project North Line after being aligned
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 1 of 2