Family Creation 3 (Advanced)
For the second upright, draw a
reference line to the right. Add
a dimensional constraint
parameter to the reference line
called UPRIGHT LENGTH.
Create a sweep using the
77mm profile. Navigate to the
reference level view, and offset
the sweep profile with 5mm as
per point 2.6
To specify the distance between
each upright member, add a
dimension from upright
reference plane to upright
reference line. If you struggle to
TAB through to dimension
between references, isolate the
references and dimension from
there. Add a dimensional
constraint parameter to the
dimension called UPRIGHT
OFFSET.
Add a parameter called ANGLE
C1 as an INSTANCE and ANGLE.
For the formula, enter the
following
In the formula row of OFFSET
HEIGHT 1, add the following:
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 10 of 12