x CCP_REVIT Full Combined CCPs | Page 245

Family Creation 2 ( parametric Arrays )
Alternative if the above process does not work then we can try the following steps .
We can re-constrain the end dimension to a reference that both cupboard door handles will have and relate to . This reference that both cupboard doors relate to is the Centre ( Left / Right ) reference plane that is in the middle of the Cupboard Door Plain & Relief Generic model families . This works because both families are built and equalized around the Centre ( Left / Right ) reference plane .
Unlock the dimensions at the end of the kitchen cupboard that are determining the distance that the cupboard doors are from the end of the kitchen Cupboards . Edit the witness lines of these dimensions to the Reference plane that you will be able to pick when hovering your dimension mouse cursor over the middle region of the Cupboard Doors . Do this for both ends of the Kitchen Cupboards .
This process can only work if we insert a formula for the new dimension that is referencing the centre ref . plane of the Cupboard door . This is because we cannot keep the dimension locked at a set distance from the edge . It will have to change as the amount of doors change and the width of the Kitchen Cupboard and sizes of the Cupboard doors change .
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : shaun @ modena . co . za
Physical Address : 5 Pont Road , Bryanston , Johannesburg
Page 48 of 50