Family Creation 2 (parametric Arrays)
Adjust the Height parameter to
make sure that the extrusion
has formed a constraint with
this reference plane.
If it has not. Then you can use
the Align tool to align the top of
the extrusion to the reference
plane or you can use the ‘push-
pull’ control to pull it upwards
again, only this time when the
extrusion snaps to the
reference plane click on the
little lock symbol that appears.
Flex the height value again.
This time the top of the
extrusion will be constrained to
the reference plane.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 16 of 50