Family Creation 2 (parametric Arrays)
In the Properties pallet. Set the
Extrusion End to 16mm. this
will set the depth of the
extrusion.
To draw the extrusion, make
sure that your rectangle draw
tool is active and start by
clicking on the cross of
Reference Planes at the top left
corner. Draw the rectangle all
the way to the bottom left
crossing of Reference planes.
You will notice that the pink
Sketch line tend to Snap to the
Reference Planes.
These lines will form their own
constraints with the Reference
Planes. It is therefore not
necessary to Lock any of these.
Select the ‘Finish Edit Sketch’
to exit the Sketch.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 12 of 50