Family Creation 1 (Basics)
To ensure that the frame stays
constrained (and will adjust) to
the wall thickness, we have to
align the profile sketch lines to
the wall reference lines. Lock
the alignment constraint.
Repeat the alignment
command as per the previous
step for the profile’s opposite
side.
Finish the edit profile
command by clicking on the
green tickmark.
Finish the sweep command by
clicking on the green tickmark
(“Finish Edit Mode”)
Save the door family. Have a
good naming convention from
the concept phase, as to avoid
editing a family and changing
the name (Which will reflect in
schedules). It will save you
time in the project’s future.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 7 of 2 0