Site and Project Setup
If you think that your building
is still cutting too much into the
topography then you can
Relocate your project again.
500mm upwards. Once done
select the topography again
and move it down by the
amount that you have
relocated the project upwards
(the building moves up but the
earth or topography has to
stay at the same place). This
should rather be done before
creating the second
topography for Cut/Fill
calculations.
You might find that this has
changed the contour label
values and they do not match
the labels or contour lines
given on the DWG. To remedy
this expand the ‘Model & Site’
panel and change the Start
value for the ‘Additional
Contours’ settings this will re-
align the Topography contour
lines with those of the DWG.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 33 of 33