Stairs & Railings
Start a new Stair by
Component.
Architecture > Stair
The main principles stays the
same:
1. Before drawing the stair,
select the type of staircase
you would like to us.
2. By default you have 3
different types
- Assembled Staircase
- Monolithic Staircase (Cast-
in-Place)
- Precast
- Changing between these
three types after the stair was
drawn will result in warnings
and sometimes losses..
3. Select run, Straight run.
4. In the Options bar, you can
now set the location line of
your staircase, aiding your
drawing capabilities. You
could also offset from the
location line (to leave a space
for supports and handrails.
5. Set the Location line to Left.
And Offset by -25mm.
6. Draw the runs on the given
reference planes.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 3 of 24