Floors, Columns & Beams
Floors and Slab Edges
1. There are 2 types of
ramps you have to create.
2. Ramp Type 1 (Ramp 1 in
the pic, there are 2, one
on each side of the
gallery). Modify the sub
elements while in site
plan view. Add a split line
and move the points at
the stair side and the split
line to -1500mm
3. The ramp should now
ramp down from the
street towards Ramp2.
(Repeat on both sides)
4. Ramps Type 2, will be
created by adding a
sloped arrow. Drop the
lowest point by -2400mm.
5. Add a handrail on ramps
type 2 and make it slope
to the floor.
6. Add a Full bore (found in
the source files) as
indicated on the
pavement. Modify the sub
elements of the pavement
and add a point where the
full bore is to -50mm
7. In Section, change the
pavement floor type so
that only the Paving falls
towards the full bore.
8. Create a new Street Kerb
Slab Edge Profile , create
a slab edge for the Kerb
and place it at the edge of
the street.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 3 of 3