Family Creation 2 (parametric Arrays)
Select the dimension and Add a
parameter to it called ‘Door
offset’. It will be a Type
Parameter and we can leave it
grouped under Dimensions.
The rest of the fields are filled
out for us by Revit.
The formula for door offset is
as follows. It needs to be based
on the Door Width / 2 +
10mm.
Change the dimension on the
other end of the Kitchen
Cupboard to have this
parameter as well. Flex the
Kitchen Cupboard family once
more and load it into the
Project.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 49 of 50