Family Creation 1 (Basics)
Draw a rectangle around the
door grille again, but this time,
because an offset has been
specified, the model lines will
offset from the mouse cursor
with 25mm.
To draw a door grille frame on
the other side of the door
panel, navigate to the “Interior”
elevation, and within the
“Create” tab, “Work Plane”
panel, click on “Set”.
Within the “Work Plane”
window that opens, click on
the “Pick a plane” option.
Within the “Interior” elevation,
highlight the door panel
extrusion, and click to set the
workplane to the interior side
of the door panel.
To draw the door grille frame
on the interior side of the door
panel, start the “Model Line”
command again.
Draw a rectangle around the
door grille extrusion. Within
the options bar, offset the lines
to 25mm.
Draw a rectangle around the
door grille again, for the frame
offsert.
Tel : 086 166 3362
Fax : 086 567 2315 e-mail : [email protected]
Physical Address : 5 Pont Road, Bryanston, Johannesburg
Page 1 9 of 2 0