Widia - frézování s VBD | KL-TECH s.r.o. | www.klte.cz widia-frézování s vbd | Page 88

Face Mills • SuperFeed ™ Series
Insert Setting and Fine Adjustment Procedure
„ 
General
• Contact gages can be used with the following precautions:
— Indicator must be fl at and parallel to the base.
— Always approach the PCD cartridge from the relief angle under the PCD segment.
— Do NOT let the indicator drop on the PCD segment.
• Remove all worn PCD cartridges.
• Clean the pockets of the cutter completely.
„ 
Face Mills
• Apply a small amount of lubricant to the following areas:
— Pocket area where the wedge slides.
— Threads of the cartridge locking screw.
— Threads of the axial adjustment screw.
• Install cartridges applying light torque to the wedge assembly locking screw.
• Turn axial adjustment screw until the cartridge is 0,01–0,015mm below the fi nal set height.
• Tighten the wedge assembly locking screw to 4 Nm.
• Turn the axial adjustment screw moving the PCD cartridge 0,005mm to the fi nal set height position.
• Set all cartridges as above.
„ 
End Mills
• Apply a small amount of lubricant to the following areas:
— Threads of the cartridge locking screw.
— Threads of the axial adjustment screw.
• Install cartridges applying light torque to the locking screws.
• Turn axial adjustment screw until the cartridge is 0,01–0,015mm below the fi nal set height.
• Tighten the locking screw (left-hand threads) to 8 Nm leaving 0,005mm below the fi nal set height.
• Turn the axial adjustment screw moving the PCD cartridge 0,005mm to the fi nal set height position.
• Set all cartridges as above.
H68
widia.com
• Non-contact gages are preferred.