ROUTING WORKTOPS
ACCURATELY
To get an accurate worktop joint the 30mm
diameter guide bush must be positioned so
that it is concentric with the 1/2” TCT cutter.
If the cutter is not concentric to the guide
bush, the finished joint will be poor.
To ensure concentricity for the guide bush for non-
Trend 1/2” routers, a universal sub-base Ref. UNIBASE
is required. This will fit directly to most routers and is
supplied with a line-up pin that is fitted to the router
collet to line-up the assembly. The sub-base can then
accept Ref. GB30/A guide bush.
ONLINE
KNOWLEDGE
For more routing tips &
techniques visit the knowledge
section on our website.
www.trend-uk.com/knowledge
Note: For some non-Trend routers that
are not compatible with the Universal
Sub-base, then
Ref. GB/5/S can be used.
GB
UNIBASE
SUB-BASE
WITH
NON-TREND
ROUTER
For full details see page 192.
ROUTING TIPS & ADVICE
CENTRING
TCT worktop cutter.
Visit www.trend-uk.com/compatibility
T10 2000
WATT ROUTER
TCT worktop cutter.
For full details see page 137.
30mm guide bush
Ref. GB30/A (see
page 183 for details).
UNIBASE to accept
guide bush & for
centring accuracy.
30mm guide bush
Ref. GB30/A.
Adjustable inner
plate to accept
guide bush & for
centring accuracy.
Non-Trend router.
Trend T10 router.
161