SPINDLE TOOLING
SOLID
CABINET DOOR
SYSTEM
The Cabinet Door System runs on a spindle moulder
with a flush mounted sliding table. It has been designed
to offer maximum flexibility and will produce nine different
profile styles with four possible panel groove thicknesses.
This enables you to produce door thicknesses from 18mm
to 35mm and up to 36 different door configurations.
O
O
O
O
O
O
O
With the CDS you can manufacture any size of cabinet door or
internal door quickly and accurately on a spindle moulder with a flush
mounted sliding table.
Set the machine in seconds with the supplied setting gauge and
do not alter it to produce all of the profiles and scribes.
Dispenses with lengthy set-up and costly test cuts.
All the tools and spacers are numbered and stacked on to the
machine according to the steps shown on the wallchart.
The CDS can manufacture nine different door profile styles.
Four panel door thicknesses can be accommodated - 4mm,
5mm, 6mm & 9mm.
Door thicknesses from 18mm to 35mm can be produced.
HOW TO SET THE MACHINE
STEP 1. Ensure both in-feed and out-feed fences are running parallel to
the front of the spindle moulder.
STEP 2. Set the tenoning fence so that it is exactly at 90 degrees to the
in-feed fence.
STEP 3. Raise the spindle shaft to its maximum height. Place the setting
gauge onto the shaft of the spindle with the largest diameter at
the bottom. Place a straight edge across the front of the fences
and adjust the fences so that the straight edge just touches the
outer edge of the largest diameter of the setting gauge
(see picture below). Lock the fences off.
STEP 4. Stand the straight edge on its side and raise the spindle shaft
until the bottom of the straight edge just touches the top of the
widest part of the setting gauge (see picture below). Lock the
spindle height adjustment.
SPINDLE MOULDER
MINIMUM
REQUIREMENTS:
O
O
O
STEP 5. Remove the setting gauge. The blue spacer can now be
installed onto the spindle. The machine is now set to run the
CDS without any further alteration.
Minimum 1.5KW (2HP) motor
power.
140mm hood aperture.
140mm inside hood diameter,
180mm required for panel raiser
IT/7781011 (see page 52).
O
30mm shaft diameter.
O
100mm usable shaft height.
All prices are exclusive of VAT
93