Mount all the hardware inside the enclosure.
I turn my jacks like this to shorten the wires.
I turn the switch in such a way to feed
the negative leg of the LED through its
corresponding switch lug.
Use the one remaining resistor lead to bridge
lugs 4 and 9 on the switch. Solder lug 4,
leave lug 9 unsoldered. Here, we will ground
the switch to the DC jack and input jack. Run
a wire through lugs 2, 3 and 6, and connect
the other end to the negative leg of the DC
jack (the one dissimilar of the three). Solder
the switch lugs, and wire the DC negative to
the input jack sleeve lug. Solder the DC jack
and wire the input jack sleeve to the output
jack sleeve. Solder the Input jack sleeve,
leaving the output sleeve unsoldered.
Mount the board and potentiometers inside
the enclosure. Attach the ground wire from
the board to the sleeve lug of the output jack
and solder it. Then attach the power wire to
the DC jack (run it through BOTH lugs), and
attach the power wire to the positive LED
leg. Attach the input and output wires from
the circuit to the footswitch.
Finally, attach the jack tip lugs to the
appropriate places on the switch.
ToneReport.com
39