STEP 1
First, install the sockets. Place them
in the board, then place a flat object
like a coaster or CD case on top. Flip it
over to hold the sockets in place and
solder.
1.
STEP 2
Install the resistors. You can solder in
the diode at this time, it’s roughly the
same size. Bend the leads, then flip
over and solder. Throw away the diode
leads (they’re too thick) but save the
resistor leads.
2.
STEP 3
Use these discarded leads as the
jumper wires. Place them, bend the
ends and solder. Your resistors may not
have long enough leads to make the
connection between M,A and M,H, so
just use a piece of wire instead. Save
just one extra lead.
3.
48
TONE TALK //
Vintage Fuzz Treasure Chest: Build Your Own SRS EQ Exciter