Timber iQ December 2018 - January 2019 // Issue: 41 | Page 57
PRODUCTS
ON THE GRIND
Affordable and long-lasting, the INGCO 950W Angle Grinder is an industrial-
performance 115mm grinder with a rated speed of 11 000rpm and an M14
spindle. With the ability to handle 1 300W maximum overload power, it
boasts an optimum cooling system.
The angle grinder has an NSK (Japanese) bearing that gives it a long
lifetime guarantee. It is also fitted with high quality carbon brushes, a long
armature and field coil, a high-quality copper and dust proof design which
leads to better performance and much longer life span.
The gearing is manufactured from high quality material that gives it three
times the life of regular gearing. Much thicker flanges and high-quality grease
round off the INGCO offering, adds to its overall durability and performance.
+27 (0)11 477 3612 | www.ingco.co.za
THE BEST CUT
Whether you’re making rip cuts, crosscuts or angled cuts up to 1 220mm
long, the portable Accu-Cut does it with super-simple setup, precise
accuracy and amazing control.
The Kreg Accu-Cut makes straight, accurate, splinter-free cuts in
plywood, MDF and other large sheets more easily as it transforms your
circular saw into a high-performance, track-guided cutting system.
The Accu-Cut design makes it simple to set up by just aligning the track
with your cut line. No clamps are required to hold the track in place thanks
to dual guide strips. They feature an anti-slip coating to prevent slipping,
and an anti-chip feature to prevent splintered cuts. Plus, the track makes it
easy to make straight cuts on sheets that don't have a straight, flat edge.
The track guides your saw straight while a universal sled holds your saw
on the track in perfect alignment. The sled accepts most left-blade or
right-blade saws. To cut, just make a couple of marks on your sheet, align
the edge of the track with the marks, and you’re set. Place the saw on the
starting block which aligns the blade and supports the saw as you start
cutting – and then slide the saw along the track. Strips on the underside
of the track hold it in place without clamps, and hug the blade to
prevent splintering.
+27 (0) 11 314 7711 | www.vermontsales.co.za
A BIT OF EVERYTHING
Tork Craft has launched its 101-piece bit drive set KT2573, a trusty
assortment kit for any tool lover, DIYer, homeowner, workshop and
service industry.
This set, which comes in a sturdy plastic toolbox, allows you to
unscrew and open anything and everything, even tackling those screws
that manufacturers don’t want you to open or unscrew.
The set includes unique specialist bits that were never available
before to the general DIYer, consumer or workshop.
+27 (0)11 314 7711 | www.vermontsales.co.za
www.timberiq.co.za
// DECEMBER 2018 / JANUARY 2019 55