Block Protector
PM Mid Plate
blown PM Mid Plate
blown PM Mid Plate- Small Hole
HEMI Block Protector
PM Mid Plate-LW
BLOWN PM Mid Plate- LW
Pro Stock Mid Plate
Blank Mid Plates
Order Toll Free at 1-800-980-9656
Block Protector
. 125” thick 6061-T6 aluminum plate fits between engine and mid plate and is used to protect rear of engine block from damage due to a clutch or flywheel explosion.
TMR-1157.......$ 125.00
PM Mid Plate
This. 250” thick aluminum plate is designed to fit between the double frame rails on a Pro Modified car and tie in the center of the engine to the chassis for an extremely solid mount. Add two of our Van 55 tabs to this
plate for ease of installation.
TMR-1156......$ 255.00
blown PM Mid Plate
Designed for our blown PM chassis this plate has a narrower width than the TMR-1156. It incorporates Chrysler and Chevy bolt patterns and has a right side starter pocket location plus stud holes for the Chrysler nose
mount starter.
TMR-1156BPM......$ 255.00
blown PM Mid Plate- Small Hole
Designed for our blown PM chassis this plate has a narrower width than the TMR-1156. It incorporates Chrysler and Chevy bolt patterns and has a right side starter pocket location plus stud holes for the Chrysler nose
mount starter.
TMR-1156ABPM......$ 275.00
Block Protectors
Mid Plates
HEMI Block Protector
Also made from. 125” 6061- T6 aluminum, this block protector is designed for the Hemi blown alcohol engines. It has the Chrysler bolt pattern and provisions for a right side starter.
TMR-1157BPM.......$ 125.00
PM Mid Plate-LW
Featuring the same dimensions as our TMR-1156 Pro Modified Mid Plate, this light weight version weighs in at only 2.75 lbs. Add two of our Van 55 tabs to this plate for ease of installation.
TMR-1156LW.......$ 420.00
BLOWN PM Mid Plate- LW
Featuring the same dimensions as our TMR-1156ABPM Mid Plate, this light weight version weighs in at only 2.75 lbs. Add two of our Van 55 tabs to this plate for ease of installation.
TMR-1156ABPM-LW.......$ 420.00
Pro Stock Mid Plate
This 1 / 4” thick aluminum plate is designed to be used in a Pro Stock type car where double frame rails are not necessary. It should be tied to the lower frame rails with tabs and a 1” o. d. tube at the top.
TMR-1156PS.......$ 225.00
Blank Mid Plates
These. 250” thick aluminum plates measure 24” X 24” and come with bolt patterns and holes to fit most crankshaft flanges and right side starters.
18
MID PLates
Blank BB Chevy TMR-1156BL.......$ 110.00 |
Blank BB Mopar TMR-1156BLBBMO.......$ 175.00 |
Blank BB Ford TMR-1156BLBBFO.......$ 175.00 |
Blank BLown Sm Hole TMR-1156ABPM-BL.......$ 195.00 |