HVAC THERMOSTATS
CONTROL PRODUCTS
SMART THERMOSTAT CONTROLLERS TEC3000 - STAND-ALONE , BACnet ® MS / TP OR N2 NETWORKED
FEATURES
• End-of-line switch - Simplifies the layout and installation of communication buses .
• Mobile Access Portal ( MAP ) Gateway compatibility ( MAP Release 4.0 or later ) - View the equipment and control the conditions through your mobile devices .
• Onboard occupancy sensor ( TEC3031-1x-000 and TEC3xx3-1x-000 Models ) - Provides energy savings in high-energy usage commercial buildings without additional installation time or cost .
• Integral humidity sensor - Monitors space humidity on all models . Activates dehumidification control on two-pipe fan coil units with reheat and four-pipe fan coil units with or without reheat .
• Multiple fan configurations for fan coil equipment types - Provide fieldselectable single-speed , multispeed , and variable-speed fan control capabilities .
• Full line of remote TE-6300 Series Temperature Sensors - Support a wide usage commercial buildings without additional installation time or cost .
• Built-in schedule object - Allows all wireless and wired models of thermostat controllers to be scheduled as stand-alone devices ; allows wireless and BACnet ® MS / TP models to be defined and adjusted through the
building automation system .
• Optimal start - Allows each thermostat controller to anticipate the heating or cooling needs of a space by starting the equipment early enough to reach the setpoint at the beginning of the scheduled occupancy .
• Auto-tuned control loops - Reduce commissioning time , eliminate change-ofseason recommissioning , and reduce wear and tear of the mechanical devices .
• Load shed - Commands a load shed input to offset the heating and cooling setpoints by a fixed amount on networked models . The change rate of the setpoints is adjustable . The load shed feature is in place to help
satisfy the California Title 24 requirements that are defined in joint appendix JA5 , section JA5.2.4 for demand signal response . The trigger for this event is defined in another controller and passed through the network command .
DIMENSIONS ( in mm )
7 - THERMOSTATS European Products Catalogue 2021