The Virtuous Daughter Magazine Winter 2016/17 Edition | Page 43

First off, you will want to start putting your paper tape on the light switch cover.

Continue this until everything is covered, including the holes.( Be sure you have plenty of extra tape so you can cover the edges.)

Once you ' re done with that, start cutting away the extra tape with the craft knife, leaving enough tape so you can smooth it down around the edges. Here you may want to use the cutting board. Also, cut the tape covering the opening and holes

After that you ' re finished! This is very simple and only takes about five to ten minutes. Also get creative and do different designs if you want. Shapes might not be the easiest, but go for it if you can!