86 • AUTOLOCKSMITHS
PROUD SPONSORS
OF THIS PAGE
STEP BY STEP GUIDE TO KEYPROGRAMMING
» » HICKLEYS, THE KEY PROGRAMMING
specialists are running a series of step
by step guides on key and remote
programming. The latest in the series is
the Ford Custom van.
This system uses a challenge and
response pin code system; however, the
MVPPro programmer has the ability to
overcome the coded protection system,
this can take up to four hours but using
1
the Smart Dongle will bypass
the coded protection system
within just eight minutes.
OVERVIEW
• Ford Transit Custom 2012-
2016 (V363) With the MVPPro &
Smart Dongle.
• Transponder Type 4D 63 Carbon 80
bit 80 bit mode
The 4D 63 transponders are available in
both 40 bit and 80 bit mode.
The new transponder must be a 4D 63
80bit transponder locked to the 80 bit
mode. If you are unsure you have the
correct transponder, read the transponder
with any cloning machine and if it says
it “can be copied” the transponder is
incorrect and will fail to program.
All vehicles covered by this application
will be fitted with a lazer HU101 blade.
3
SELECT:
• Ford
• Transit
Custom
• +2014-
>2016
5
4
6
As this is an additional key, select ADD KEY.
7
2
OBD location is driver side lower
dash behind the pulldown cover.
Battery voltage must be over 12v a
battery support unit or jump pack is
recommended.
Once you gain access to the
system the diagnostic menu
will display the following:
• Clear keys
• Add key
• Keys programmed
• Clear fault codes
• Reset
With the ignition turned
on with the new key to
be programmed and the
smart dongle connected,
the wait time is reduced
from up to four hours
down to within eight
minutes.
Once the MVPPro has gained access to the vehicle immobiliser
system you will get the on-screen message Detecting key
success.
Press enter on the MVPPro and back out to the menu screen.
NOTE:
On a lost or stolen key scenario you will need to erase the
immobiliser system and program a minimum of two keys.
LOCKSMITHJOURNAL.CO.UK | NOV/DEC 2017
Sponsored by ABUS