PROUD SPONSORS OF THIS PAGE
HINTS & TIPS • 53
9 10
Next , push the cable guide and spindle through the holes in the door . Then slide the lugs up and down to align with the existing holes and push the handle onto the door . You can now remove the cable guide , this is no longer required .
11 12
Fit the alignment tool to the internal fixing plate , making sure it is pushed all the way on and the handle is parallel to the door on both sides . Next , make sure the alignment tool is flat against the door and tighten all the screws fully .
13 14
Make sure the arrows on the tailbar housing are pointing up . Mount the internal handle onto the door over the spindle and tailbar making sure to fold the cable into the cavity on the internal handle .
Please note : the thumbturn should not be moved until the installation is complete .
15 16
Make sure the lever handle operates freely once the screws are tightened . Insert batteries and attached the battery cover .
17 18
You will now need to pair a card / tag . Press the R button to start . The light on the front of the lock should now turn purple . Hold the tag / card against the external reader under the Yale until the light turns green .
Please note : only one card / tag can be paired this way , subsequent cards / tags can be paired later using the app .
Mount the internal fixing plate , making sure the cable goes through the bottom slot . Choose the new screw and insert either above or below the lever – this will correspond to where your lug was installed in the previous step . Do not tighten fully at this stage .
Now remove the alignment tool being careful not to remove the spindle , this is no longer required . Take the cable and push it into the slot in the back of the internal handle , lining up the two red sides of the connector .
Remove the radio and battery covers . Tighten all the screws in place ensuring the handle stays aligned .
Now , hold the R button for fifteen seconds , waiting for the two beeps . Press the lever handle fully down and release , then lift the lever handle up fully .
Press the R button to finish . The card / tag is now paired .
The Yale Conexis ® L1 Smart Door Lock is now fitted .
For full , detailed fitting instructions , please refer to the “ how to ” video on the Yale YouTube channel : https :// www . youtube . com / watch ? v = zX3bO-2efOI For further information on Yale ’ s range of Smart Door Locks or the complete of Smart Living range of connected security products , please visit www . yale . co . uk / smartliving
LOCKSMITHJOURNAL . CO . UK | MAY / JUN 2018 Sponsored by Insafe | Loksafe . co . uk | Insafe . com