HINTS&TIPS • 33
PROUD SPONSORS
OF THIS PAGE
7
Insert both spring sets into
the cavity in the back of
the handle.
11
Fit the alignment tool to
the internal fixing plate,
making sure it is pushed
all the way on and the
handle is parallel to the
door on both sides. Next,
make sure the alignment
tool is flat against the door
and tighten all the screws
fully.
15
16
8
9
Ensuring the lever is the
correct orientation for your
door, take the spindle from
the fixing pack and make
sure it’s pushed all the way
into the lever handle.
12
10
Next, push the cable guide
and spindle through the
holes in the door. Then
slide the lugs up and down
to align with the existing
holes and push the handle
onto the door. You can now
remove the cable guide,
this is no longer required.
13
Now remove the alignment
tool being careful not to
remove the spindle, this is
no longer required. Take
the cable and push it into
the slot in the back of the
internal handle, lining up
the two red sides of the
connector.
Make sure the
lever handle
operates freely
once the screws
are tightened.
Insert batteries and
attached the battery
cover.
Now, hold the R
button for fifteen
seconds, waiting
for the two beeps.
Press the lever
handle fully down
and release, then
lift the lever handle
up fully.
14
Make sure the arrows on
the tailbar housing are
pointing up. Mount the
internal handle onto the
door over the spindle and
tailbar making sure to fold
the cable into the cavity on
the internal handle. Please
note: the thumbturn should
not be moved until the
installation is complete.
17
Mount the internal fixing
plate, making sure the
cable goes through the
bottom slot. Choose the
new screw and insert
either above or below the
lever – this will correspond
to where your lug was
installed in the previous
step. Do not tighten fully at
this stage.
Remove the radio and
battery covers. Tighten
all the screws in place
ensuring the handle stays
aligned.
18
Press the R button to finish.
The card / tag is now paired.
You will now need to pair
a card / tag. Press the R
button to start. The light
on the front of the lock
should now turn purple.
Hold the tag / card against
the external reader under
the Yale until the light turns
green. Please note: only
one card/tag can be paired
this way, subsequent
cards/tags can be paired
later using the app.
LOCKSMITHJOURNAL.CO.UK | JAN/FEB 2018
Sponsored by Lockex 2018 - Security & Fire Safety
The Yale Conexis® L1 Smart Door
Lock is now fitted. For full, detailed
fitting instructions, please refer to the
“how to” video on the Yale YouTube
channel: https://www.youtube.com/
watch?v=zX3bO-2efOI
For further information on Yale’s range
of Smart Door Locks or the complete
of Smart Living range of connected
security products, please visit
www.yale.co.uk/smart-living