Subaru WRX & WRX STI Manuals 2020 WRX & WRX STI Multimedia System Manual | Page 77

OTHER SETTINGS
4.
After downloading has completed, check that “Software
Update Ready To Install” is displayed.
INSTALL UPDATE
Ɣ If you are ready to install the update, proceed to
³,167$//83'$7(´ĺ3
Ɣ If you wish to install the update later, select Cancel
(Cancel).
Ɣ If the “Connect To Wi-Fi” pop-up is displayed:
Perform the “CONNECTING TO THE NETWORK”
SURFHGXUHDJDLQĺ3
Ɣ If the “Your device’s software is up to date.” pop-up is
displayed:
The system software is already the latest version and
update is not necessary.
Ɣ If the “Software download failed. Do you want to
retry?” pop-up is displayed:
The system clock may not be set correctly.
Move the vehicle to where GPS signals can be
received normally or connect a smartphone via
Bluetooth to adjust the clock.
Perform the “UPDATE THE CLOCK” procedure again.
ĺ3
O The engine does not need to be running to update the system.
If you leave the engine running while downloading or installing
DQXSGDWHGRQRWSDUNWKHYHKLFOHLQDFRQ¿QHGVSDFHVXFK
as a garage. Doing so could cause serious injury or death.
CAUTION
O Park your vehicle in a safe place and do not operate it while
the update is installing.
O The following system functions are restricted during the
update installation.
• It will not be possible to use general system functions.
• The rear view camera may be fully or partially disabled
during the update. The help line (distance marker, dynamic
guidelines and vehicle width line) will not be displayed.
1.
2.
Select
(Install Now).
Ɣ The update will begin installing.
Wait until the update installation has completed.
Ɣ Approximate time to complete installation: 10 minutes
Ɣ If the update procedure fails, refer to the “WHAT TO
'2,)´VHFWLRQĺ3
75
3
Ɣ If Cancel (Cancel) is selected, it will be necessary to
perform the “DOWNLOAD UPDATE” procedure again
IURP³67(3´ĺ3
WARNING