Subaru WRX & WRX STI Manuals 2018 WRX & WRX STI Owner’s Manual | Page 170

3-32
Instruments and controls/Warning and indicator lights
Inside warning
chime
Long beep
(continuous)
Outside warning
chime
Long beep
(continuous)
Operation indicator
on push-button igni-
tion switch
Status
Action
— Access key takeout without “P” po-
sition warning:
The driver exited the vehicle with the
Shift the select lever to the “P” position,
access key fob and closed the driver’s switch the push-button ignition switch to
door while the push-button ignition
“OFF” and exit the vehicle.
switch is in a position other than “OFF”
and the select lever is in a position other
than the “P” position.
Long beep
(continuous) — — Select lever position warning:
.
. Case 1: The driver’s door was
opened while the push-button igni-
tion switch is in a position other than
“OFF” and the select lever is in a
position other than the “P” position. .
. Case 2: The engine is turned off by
pressing the push-button ignition
switch and the select lever is in a
position other than the “P” position.
Ding — — the battery of the access key
The battery of the access key fob is low. Replace
fob.
Ding — Ding —
NOTE
Flashes in green (15 Steering lock warning:
The engine start procedure was per-
seconds max.)
formed, but the steering is still locked.
Flashes in orange
Case 1: Shift the select lever to
the “P” position, switch the push-
button ignition switch to “OFF” and
exit the vehicle.
Case 2: Start the engine, shift
the select lever to the “P” position,
switch the push-button ignition
switch to “OFF” and exit the vehicle.
While turning the steering wheel right
and left lightly, depress the brake pedal
and press the push-button ignition
switch.
System malfunction warning:
Contact a SUBARU dealer immediately
A malfunction was detected in the power and have the vehicle inspected.
system or steering lock.
An electronic chirp will sound while the select lever is in the “R” position. In this case, the select lever position warning chime
will not sound.