Subaru WRX & WRX STI Manuals 2017 WRX & WRX STI Owner’s Manual | Page 122
Keys and doors/Alarm system
. Carry the access key and grip the front
door handle (models with “keyless access
with push-button start system”).
! To arm the system using the keyless access function (if equipped)
1. Close all windows and the moonroof (if
equipped)
2. Turn the push-button ignition switch to
the “OFF” position.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood is
locked.
5. Close all doors and the trunk lid.
The flashing of the security indicator light
will then change slowly (once approximately every 3 seconds from twice approximately every 2 seconds), indicating
that the alarm system has been disarmed.
Security indicator light
6. Carry the access key and touch the
door lock sensor. All doors will lock, an
electronic chirp will sound once, the
hazard warning flashers will flash once,
and the security indicator light will start
flashing rapidly. After rapid flashing for 30
seconds (standby time), the security indicator light will then flash slowly (twice
approximately every 2 seconds), indicating that the system has been armed for
surveillance.
1)
2-29
Door lock sensor
& Disarming the system
Perform either of the following procedures.
. Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
! Emergency disarming
If you cannot disarm the system using the
access key/transmitter (i.e. the transmitter
is lost, broken or the transmitter battery is
too weak), you can disarm the system
without using the access key/remote
transmitter.
The system can be disarmed if you turn
the ignition switch from the “LOCK”/“OFF”
to the “ON” position with a registered key/
access key.
NOTE
For models with “keyless access with
push-button start system”, if the access key battery is discharged, perform
the procedure described in “Switching
power status” F9-16. In such a case,
replace the battery immediately. Refer
to “Replacing battery of access key”
F11-50.
– CONTINUED –