Subaru WRX & WRX STI Manuals 2016 WRX & WRX STI Owner’s Manual | Page 451

7-62

Starting and operating/BSD/RCTA

nation meter, and the BSD/RCTA is
deactivated.
Press the switch again to activate the
BSD/RCTA. The BSD/RCTA OFF indicator disappears.

NOTE
. In the following cases, press the
BSD/RCTA OFF switch to deactivate
the system. The system may not operate properly due to blocked radar
waves.
– When towing a trailer
– When a bicycle carrier or other
item is fitted to the rear of the
vehicle
– When using a chassis dynamometer or free roller device, etc.
– When running the engine and
making the wheels rotate while
lifting up the vehicle
. If the ignition switch is turned to the
“LOCK”/“OFF” position, the last known
status of the system is maintained. For
example, if the ignition switch is turned
to the “LOCK”/“OFF” position with the
BSD/RCTA deactivated, the BSD/RCTA
remains deactivated the next time the
ignition switch is turned to the “ON”
position.
. If the vehicle battery is disconnected
due to situations such as battery

terminal or fuse replacement, after the
battery is reconnected, the BSD/RCTA
will be activated.

& Certification for the BSD/
RCTA
. U.S.-spec. models
FCC ID: OAYSRR2A

CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the
equipment.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
. Canada-spec. models
This device complies with
Canada licence-exempt RSS
(s). Operation is subject to the
two conditions: (1) this device

Industry
standard
following
may not

cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur
de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le
fonctionnement.