Subaru WRX & WRX STI Manuals 2015 WRX & WRX STI Owner's Manual | Page 458

Maintenance and service/Replacing bulbs

the headlight assembly by turning it clockwise.
4. Replace the bulb with new one. At this
time, use care not to touch the bulb
surface.
5. To install the bulb to the headlight
assembly, turn it to the reverse direction
until it clicks.
6. Reconnect the electrical connector.
7. Left-hand side: Set the washer fluid
filler pipe to the original place and secure it
by clip.
Right-hand side: Install the air intake
duct with clips.

& Low beam headlight (models
without LED headlights),
front side marker light (if
equipped), parking light
(models without LED headlights) and front turn signal
light
NOTE
. If headlight aiming is required, consult your SUBARU dealer for proper
adjustment of the headlight aim.
. It may be difficult to replace the
bulbs. Have the bulbs replaced by your
SUBARU dealer if necessary.
1. Start the engine and turn the steering

wheel fully in the opposite direction of the
bulb to be replaced.
2. Stop the engine.

11-45

! Low beam headlight

3. Remove the clips from the mud guard.

1. Disconnect the electrical connector
from the bulb as pushing the tab.
4. Pull off the mud guard.
– CONTINUED –