Subaru WRX & WRX STI Manuals 2013 Impreza WRX & WRX STI Owner's Manual | Page 37

Seat, seatbelt and SRS airbags

1)
2)

When not used (lowest position)
When used (click position)

To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks.
When the rear-center seating position is
occupied, raise the head restraint to an
appropriate position depending on your
sitting height. When the rear center seating position is not occupied, lower the
head restraint to improve rearward visibility.

1-9

And make certain that the
shoulder belts are fully visible.
. Never allow passengers to ride
on the folded rear seatback or in
the cargo area or trunk. Doing so
may result in serious injury or
death.
. Secure all objects and especially
long items properly to prevent
them from being thrown around
inside the vehicle and causing
serious injury during a sudden
stop, a sudden steering maneuver or a rapid acceleration.
! 4-door models
1. Lower the head restraints.

& Folding down the rear seatback
WARNING
1)
2)

Head restraint
Release button

. After returning the rear seatback
to its original position, be certain
to place all of the seatbelts and
the tab attached to the seat
cushion above the seat cushion.

2. Unlock the seatback by pulling the
– CONTINUED –