Subaru WRX & WRX STI Manuals 2012 Impreza WRX & WRX STI Owner's Manual | Page 146

3-28

Instruments and controls

& Average fuel consumption

corresponding to that trip meter indication is not shown until the vehicle has
subsequently covered a distance of 1
mile (or 1 km).

& Turn off display of fuel consumption indicator

1)
2)

U.S.-spec. models
Except U.S.-spec. models

This indication shows the average rate of
fuel consumption since the trip meter was
last reset.
When either of the trip meter indications is
reset, the corresponding average fuel
consumption value is also reset.

NOTE
. The indicated values vary in accordance with changes in the vehicle’s
running conditions. Also, the indicated
values may differ slightly from the
actual values and should thus be
treated only as a guide.
. When either trip meter indication is
reset, the average fuel consumption

The display of the fuel consumption
indicator can be turned off.
To turn off the display of the indicator, turn
the ignition switch to the “LOCK” position
and press the “+” button adjacent to the
information display for approximately 5
seconds. Then, the information display
and the clock display will blink for 3
seconds to notify that the display of the
fuel consumption has been turned off.
To restore the indicator, once again press
the “+” button for approximately 5 seconds.

NOTE
. The initial display setting of the fuel
consumption indicator of your vehicle
has been set to operational at the time
of shipment from the factory.
. The average fuel consumption is
calculated even while the indicator is
not displayed.
. Even if you turn off the fuel consumption indicator, the fuel consumption indicator will automatically turn on

when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.