Subaru WRX & WRX STI Manuals 2011 Impreza WRX & WRX STI Owner's Manual | Page 132

3-12 Instruments and controls NOTE Even if the REV alarm system is not set, the REV indicator light will illuminate whenever the engine speed enters the tachometer’s red zone. & Setting the alarm-level engine speed 1. Push the trip knob to select “REV” on the combination meter. 2. When the trip knob is pushed for more than 2 seconds, the thousands place flashes. 3. Release your finger from the trip knob once, then push and hold the trip knob again. The number will change sequentially from 2 to 7. Release your finger at the desired alarm-level engine speed. 4. When the trip knob is pushed, the hundreds place flashes. 5. Release your finger from trip knob once, then push and hold the trip knob again. The number will change sequentially from 0 to 9. Release your finger at the desired alarm-level engine speed. 6. When the trip knob is pushed, the buzzer sounds and the REV alarm system will automatically enter its new setting mode (step 7 below), in which you can activate or deactivate the buzzer. The alarm-level engine speed can be set (in 100 rpm steps) within the range from 2,000 rpm to 7,000 rpm. 7. Every time that the trip knob is pushed and held, the buzzer changes to activate or deactivate. b – on: Activated b – off: Deactivated When the mode is changed to “activate”, the buzzer sounds. 8. Push the trip knob to complete the setting procedure. NOTE . The REV alarm system does not operate while settings are being entered. . The speed-setting mode terminates if “--00” rpm is selected. . The speed-setting mode is canceled if the ignition switch is turned from ON