Subaru WRX Manuals 2026 WRX Multimedia System Manual | Page 10

INTRODUCTION
NOTE llSUBARU CORPORATION is not responsible for any damages to the purchaser or third parties that occur from using the map data. llWe do not provide any replacements or refunds for any mistakes there may be in the map data displays or contents, such as misspelling, omissions or misaligned positions. llSUBARU CORPORATION makes no guarantee that the functions included in the map data will be appropriate for the specific objectives of the purchaser. llFunctions that cannot be operated while driving have their colors toned down when the vehicle is being driven, and their operation is disabled. Touching a disabled switch may result in the display of an operation prohibited message on the screen. llDuring strong vibrations, such as when driving on a poor road surface, the unit may no longer be able to read the data from the disc, and it will not operate correctly. When the vibration lessens, normal operation will return after a short time.* llImmediately after turning on the heater when the temperature is low, dew( water drops) may adhere to the lens of the CD reader( condensation). If this happens, leaving the unit for about an hour should remove the condensation and return the unit to normal operation. If the unit does not return to normal operation even after several hours, contact your SUBARU dealer.* llWhen using the unit for the first time after purchase, or after the battery was removed for a long time, the current position may not be displayed correctly. Wait a short time until the GPS positioning corrects the displayed position. llThis device is precision-engineered equipment and the recorded data can be lost as a result of static electricity, electrical noise, vibration, or other influences. To protect the device against data loss, we recommend keeping a separate record of the data that you record after purchase.
NOTE
llThe screen may be adversely affected or disturbed by noise if electrical equipment that generates powerful electrical noise is used near the system. In such cases, keep the electrical equipment at a distance, or refrain from use. llThe display may appear brighter when the temperature is low, or immediately after starting the engine, however, this is a characteristic of the LED elements, and does not indicate a fault. The display will return to its original brightness when the vehicle cabin has warmed up. llWhen you look at the screen through polarized material such as polarized sunglasses, the screen may be dark and hard to see. If so, look at the screen from different angles, adjust the screen settings on the general settings screen or take off your sunglasses. llIt may be difficult to view the screen if the display is exposed to sunlight from an awkward angle. llThe LCD screen may not function normally if covered with a protective film. Do not affix a protective film. llThe touch panel may function incorrectly or fail to respond if operated with objects other than fingers( nails, operation when wearing gloves, pens, etc.) llIf the system functions unexpectedly such as an area other than the one touched being selected, or failure to respond when touched, there is a possibility that another finger or part of the hand is in contact with display. llScratches on the system panel surface are easily noticeable, and it should therefore be handled with care. llIf a device that uses wireless communication is installed in the vehicle, functions using a Bluetooth device, the radio broadcast receiver, navigation system, etc. may not operate properly.
*: If equipped with a CD player
8