Towing 397 |
||||||
threaded hole until the threads can no longer be seen. |
er operation of the SRS airbag system in a frontal collision. |
the cover and pry open the cover. |
||||
CAUTION |
||||||
To prevent deformation to the bumper and the towing hook, do not apply an excessive load to the towing hook. |
||||||
|
4. Tighten the towing hook securely using the jack handle.
After towing, remove the towing hook from the vehicle and stow it in the under-floor storage compartment.
Fit the towing hook cover on the bumper.
|
Rear towing hook:
1. Take out the screwdriver, towing hook and jack handle from the under-floor storage compartment.
|
3. Screw the towing hook into the threaded hole until its thread can no longer be seen. |
In Case of Emergency
9
|
|||
WARNING |
||||||
|
. Do not use the towing hook for purposes other than towing your vehicle.
. Be sure to remove the towing hook after towing. Leaving the towing hook mounted on the vehicle could interfere with prop-
|
2. Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch the bumper. Insert the flathead screwdriver into the cutout of |
4. Tighten the towing hook securely using the jack handle. |
||||
– CONTINUED – |