370
Winter Driving
– Speedometer / Odometer calibration
– Clearance between the body and the tires
It also may be dangerous and lead to loss of vehicle control, and it can lead to an accident.
. Do not use a combination of radial, belted bias or bias tires since it may cause dangerous handling characteristics and lead to an accident.
Your vehicle is equipped with“ summer tires” as original equipment, which are inadequate for driving on slippery roads such as on snow-covered or icy roads.
If you choose to install winter tires on your vehicle, be sure to use the correct tire size and type. You must install four winter tires that are of the same size, construction, brand and load range and you should never mix radial, belted bias or bias tires since this may result in dangerous handling characteristics. When you choose a tire, make sure that there is enough clearance between the tire and vehicle body.
Remember to drive with care at all times regardless of the type of tires on your vehicle.
& Tire Chains CAUTION s08ai05
Tire chains cannot be used on your vehicle because of the lack of clearance between the tires and vehicle body.
NOTE
When tire chains cannot be used, use of another type of traction device( such as spring chains) may be acceptable if use on your vehicle is recommended by the device manufacturer, taking into account tire size and road conditions. Follow the device manufacturer’ s instructions, especially regarding maximum vehicle speed.
To help avoid damage to your vehicle, drive slowly, readjust or remove the device if it is contacting your vehicle, and do not spin your wheels. Damage caused to your vehicle by use of a traction device is not covered under warranty.
Make certain that any traction device you use is an SAE class S device, and use it on the front wheels only. Always use the utmost care when driving with a traction device. Overconfidence because you are using a traction device could easily lead to a serious accident.
& Rocking the Vehicle s08ai06
If you must rock the vehicle to free it from snow, sand, or mud, depress the accelerator pedal slightly and move the shift lever / select lever back and forth between“ 1”/“ D” and“ R” repeatedly. Do not race the engine. For the best possible traction, avoid spinning the wheels when trying to free the vehicle.
When the road surface is extremely slippery, you can obtain better traction by starting the vehicle with the transmission in 2nd than in 1st( MT models and CVT models).
If your vehicle is a CVT model, for information about holding the transmission in the 2nd position, refer to“ Selection of Manual Mode” FP295.