316
Parking Your Vehicle
Auto Vehicle Hold indicator light
While the vehicle is kept stopped by the Auto Vehicle Hold function, the Auto Vehicle Hold indicator light will flash.
! To release the Auto Vehicle Hold function s07ap030504
Perform any of the following operations to release the Auto Vehicle Hold function.
. Depress the accelerator pedal.. Depress the brake pedal again.. Apply the electronic parking brake.
. Shift the select lever to the“ P” position with the brake pedal pressed.
. Deactivate the Auto Vehicle Hold function operating with the center information display while depressing the brake pedal.
When the Auto Vehicle Hold function is released, the Auto Vehicle Hold indicator light will change from flashing to illuminated.
Under any of the following conditions, the Auto Vehicle Hold function will be automatically released and the electronic parking brake will be automatically applied.
. The Auto Vehicle Hold function has been in operation for 10 minutes.
. The driver’ s seatbelt is unfastened.
. The ignition switch is turned to the“ OFF” position.
. The vehicle is stopped on a steep slope.
. The Auto Vehicle Hold function is malfunctioning.
In such cases, the Auto Vehicle Hold light will turn off and the electronic parking brake indicator light will illuminate.
! Tips s07ap030505
. When the electronic parking brake is automatically applied with the vehicle kept stopped by the Auto Vehicle Hold function, release the electronic parking brake by either of the following operations before starting off. Then make sure that the electronic parking brake indicator light is off.
– Depress the accelerator pedal with the driver’ s seatbelt fastened and with the doors closed.
– Press the electronic parking brake switch with the brake pedal depressed.
. Under certain conditions, including a malfunction of the Auto Vehicle Hold, a warning buzzer will sound and a warning message will appear on the combination meter. All warning messages should be strictly observed.
. On a steep slope, the vehicle cannot be kept stopped by the Auto Vehicle Hold function. In such a case, depress and hold the brake pedal.
. When stopping on a steep slope with the Auto Vehicle Hold function activated, the electronic parking brake may be automatically applied after stopping, then the electronic parking brake indicator light may flash. In such a case, depress and hold the brake pedal while stopped. Otherwise, the vehicle may move. When getting out of the vehicle, stop the vehicle on a flat surface, then apply the electronic parking brake.
. If the Auto Vehicle Hold indicator light does not illuminates even after touching“ Auto Vehicle Hold( AVH)” with the operating conditions met, the function may have a malfunction. Contact your